DAA Auto Case Lubricator (ACL) | Step-by-Step Installation & Review

The DAA Auto Case Lubricator (ACL) provides a clean, efficient solution to a common reloading challenge: keeping your case feeder and feed tubes free of sticky residue while ensuring smooth case resizing.

By automating the process, the DAA ACL eliminates the need to pre-spray brass—an inconsistent, messy method that often forces unwanted lubricant into the case interior. Mounted directly inline, this innovative automated case lube system applies a perfectly controlled film of lubricant to the exterior of each case just before it hits the shell plate.

How the DAA Auto Case Lubricator Works

The system utilises four adjustable wicks that draw case lube from an integrated reservoir, ensuring 360-degree, consistent coverage. You can easily fine-tune your lubrication levels by:

1. Adjusting the lubricant level inside the reservoir.

2. Fine-tuning how far the wicks protrude into the case path.

Press Compatibility

The DAA Auto Case Lubricator is engineered to mount on any progressive reloading press utilizing a vertical 18 mm case-feed tube.

• Fully Compatible: Dillon 650, 750, 1050, 1100, and 1250.

• Modification Required: The included tubes are too short out-of-the-box for the Frankford Arsenal X-10. X-10 users will need to cut their original factory pipe or purchase a spare extension tube.

• Caliber Range: Fits handgun and rifle cases ranging from 9 mm up to .45 caliber.

DAA Auto Case Lubricator Setup & Installation Guide

The unit includes two clear tube sections (88 mm and 350 mm) that yield a total assembled length of 474 mm. Because these tubes are intentionally long, you must trim them to match your specific Dillon press configuration.

Step 1: Measuring and Cutting the Feed Tubes

1. Assemble: Insert the short (88 mm) tube into the bottom of the lubricator body and the long (350 mm) tube into the top. Ensure both are fully seated.

2. Compare: Stand the assembled DAA unit upright next to your press’s original factory case feeder tube to mark your target height.

3. Cut: Use a hacksaw or tubing cutter to trim the long tube to size. Crucial Tip: Only cut the non-chamfered end. The factory-chamfered ends must remain at the top of each section to ensure seamless case feeding without snags.

Step 2: How to Adjust the Lubricator Wicks

Proper wick positioning ensures smooth operation without causing case feed jams. To adjust:

1. Remove the two exterior O-rings and lift off the reservoir cap. (Upon reassembly, make sure the drain tube aligns perfectly with its retaining clip).

2. For Large Calibers: If the wicks protrude too far, they can block the case path. Gently pull the wicks outward to widen the clearance.

3. For Insufficient Lube: If cases are coming out dry, gently push the wicks inward until they make light, consistent contact with the passing brass.

Operating Instructions & Best Practices

• Secure the Drain Line: Before filling, lock the fluid drain tube into its raised position using the built-in retaining clip.

• Fill the Reservoir: Pour your preferred case lubricant into the reservoir. Beginner Tip: Start by filling it only one-third full to avoid over-lubrication, then add more as needed.

• Allow to Prime: Wait 1 to 2 minutes during your first setup to allow the wicks to fully absorb and draw the case lube.

• Post-Session Cleanup: When you are done reloading, lower the drain tube to empty any remaining lubricant back into a sealed container. Do not leave lube in the reservoir, as alcohol-based reloading lubricants will quickly evaporate and dry out the wicks.